More Fin Trim Fun

Following on from the previous post, time for a bit more fine-tuning of the replacement fin section for the bumper.

Out with the junior hacksaw for some precise cutting:

Once a full bumper, now reduced to 60cm wide piece!

Then followed quite a lot of cut-a-bit, measure-a-bit, cut-a-bit, trial-fit, measure, cut, try, repeat, repeat... until:

Okay, so the plastic is a little wonky in the middle, but this tidies-up the front-end instantly. On with a quick coat of black plastic bumper paint and I've a little something else in store before final fitment... don't worry, it's not that horrible boy-racer mesh grille or anything too tacky!!!